Article

  1. Home
  2. article
  3. What should I do if the hammer crusher operator makes a mistake in the operation and the material is too thick?

What should I do if the hammer crusher operator makes a mistake in the operation and the material is too thick?

ren

Leon

2020-11-10 03:57:54 1082

We all know that the artificial sand production line has strict requirements on the granularity of sand and gravel, so what should be done if the finished product particles caused by the operator error of the hammer crusher are too coarse

Strictly speaking, the finished particles that are too coarse are to be discarded. In order to save energy, we must process these sands. When the hammer crusher manufactures artificial sand, it usually causes the finished particles to be too coarseThere are many factors such as the diameter of the sieve hole in the hammer-broken screen and the ventilation volume.

If the hammer-broken screen is damaged and the particles caused by the excessive diameter of the screen hole are too thick, it can be repaired.Holes or replace the sieve plate. If the sieve plate and the sieve frame are not tightly fitted or the side gap is too large, only need to adjust the gap. These are the follow-up solutions, but if the finished particles are too coarse, they shouldWhat to do?

To sum up the reasons, in addition to the design of the screening mechanism at the discharge port of the hammer crusher, our factory also added an external screening and recovery device to make the finished particles too coarse.The material is crushed again to make sand, so as to achieve the effect of curing both symptoms and root causes.